Vehicles Equipped with Stock Fog Lamps:
- Remove the stock fog lamp assembly from fascia, save stock bolts for reuse.
- Install "J-clip" from hardware kit onto bottom hole of driving lamp bracket.
- Install dual driving lamp and bracket assembly, onger a of the top arms go to the inside, into the stock locations using the stock bolts.
- Splice the white wires from driving lamps to the "hot" wire the stock fog lamp wiring harness, and the black wires from the driving lamps to the "ground" wire of the stock fog lamp wiring harness.
- Turn lamps on, visually check the light beam, turn off lamps and adjust the lamps angle. (let the lights cool down before each adjustment.)
Vehicles Not Equipped with Stock Fog Lamps:
- Remove slats that run cross fog lamp opening with exact knife.
- Install "J-clip" from hardware kit onto bottom hole of driving lamp bracket.
- Install "J-clip" onto the bosses located above fog light openings on the fascia, 2 on each side.
- Install dual driving lamp and bracket assembly, longer a of each bracket GOF's to the inside, secure using the 6 screws, provided in hardware kit.
- Wire lamps in accordance to enclosed diagram.
- Adjust accordingly, remembering to let the lights cool before each adjustment.
Note: To ensure proper functioning of driving lamps, operate only 2 lights on one switch.
