Mustang Directional Mirror Installation

Mustang Directional Mirror Installation - Open the driver side door and lower the window. Remove the door panel, speaker, kick panel and plastic trim piece along the bottom of the doorframe. (see picture)
  1. Open the driver side door and lower the window. Remove the door panel, speaker, kick panel and plastic trim piece along the bottom of the doorframe.
  2. Disconnect the mirror wire harness.
  3. Remove the three mirror mounting nuts and remove the mirror housing from the vehicle.


You may also be interested in . . .

    1. Open Trunk.
    2. Remove four (4) "Christmas Tree" pushpins that hold plastic trim panel at striker plate and remove plastic trim.
    3. Remove two (2) plastic speed nuts (phillips head) one per side, directly behind each taillight in trunk. Remove trunk panel.
    4. Remove four (4) nuts per taillight housing (11 mm).
    5. Unplug wiring harness (one connection per light).
    6. Push grommets (one per light) with wiring harness through the sheet metal from inside to outside of trunk.
    7. Remove taillight housings from vehicle.
    8. With taillights on bench, remove bulbs and sockets from lights and remove harnesses completely.
    9. Install bulbs in modified harnesses (make sure to wipe bulbs with isopropyl alcohol to avoid bulb burnout from hand grease).
    10. Connect backup light bulbs and sockets to the lamp bodies first, then connect bulbs/sockets marked 1, then 2, and then J.
  • Mustang Light Bar

  • Camaro / Firebird / Trans Am Light Bar Installation Instructions:

    1. Lower convertible top.
    2. Remove seat buns (2) 13mm bolt.
  • Ever look closely at that clear plastic cover over your gauges? If you look close you'll notice that there are tons of very fine scratches on it, which dull its look. Have you ever gotten dash cleaner/polish on that plastic? I did, and the cleaner stained the plastic. No matter how much I scrubbed I couldn't get the stains off of the plastic.

    There are kits that you can buy which include some type of polish to get those scratches out, but why spend money when you probably have everything you need to polish your gauge cover already?

  • When your fox mustang gets along in years, one of the early things to go is the headliner.

  • This article will adress on how to install a Mass Air system in a speed density equiped mustang.

  • Here is what I have. A 130amp alternator complete with stator wire, short bolt, and with no exchange required. Mine came with the standard finish for $145.00 with shipping included.