• Unplug the negative battery terminal THIS IS VERY IMPORTANT.
• Disconnect your starter from your bellhousing.

PARTS NEEDED:

• 2 DOLLAR TOGGLE SWITCH
• 14 GAUGE WIRE
• SHRINK-TUBING
• STARTER-RELAY

PARTS NEEDED / PARTS USED:

• 15 ft. of 1 gauge wire,(Lugged on both ends).
• 15ft. of 4 gauge wire, (Lugged on both ends).

You have probably noticed some wires and a plug hanging loose by now. You can either find a way to make the neutral safety switch work, or you can do what I did.

Ok, it is time to put the c4 in.

You are looking at about $1200 for everything if you plan on beefing up the c4 instead of using the stock parts for it.

The only major difference between changing a Fox water pump, compared to the 94/95 SN95's waterpump removal, is the following bracket that is next to come off.

Removal of the water pump is fairly simple, requires a decent Standard/Metric 6pt and 12pt socket set, and a few other basic hand tools.

It helps if you have a good manual but the instructions that come with the kit are pretty good. The part number is F5AZ-4947-BA.

Cut the insulator off the bottom lengthwise so it will come off, then wind it onto the bottom of your new spring.

Clean off the crud out of the lower spring perch.